Published: 19 September 2013
Effective: 19 September 2013

ATA Chapter: 27

Subject:

Stabiliser Hinge Assembly Fasteners - Inspection and Replacement

Applicability:

Beechcraft models 23, A23, A23A, B23, C23, A23-24, A24, A24R, B24R and C24R aircraft

Applicability:

Beechcraft models 23, A23, A23A, B23, C23, S/N M-1 through to M-2392,
Beechcraft models A23-24, A24, S/N MA-1 through to MA-368, and
Beechcraft models A24R, B24R, C24R S/N MC-2 through to MC-795.

Purpose:

This Continuing Airworthiness Notice (CAN) is issued to provide additional information to operators and maintainers about the stabiliser hinge assembly inspections mandated by Airworthiness Directive DCA/B23,24/17 (FAA AD 87-02-08 refers).
This AD requires a visual inspection of the fasteners securing the stabiliser hinge assemblies to the aircraft fuselage for looseness or failure. If any fasteners are found loose or failed, the AD requires the replacement of all the fasteners securing both the left and right assemblies to the fuselage.

Background:

This CAN is prompted by an overseas report of finding failed stabiliser hinge bracket attach fasteners (rivets) in a condition not anticipated by the aircraft manufacturer. An aircraft was inadvertently released to service with defective stabiliser hinge rivets after the stabiliser hinge assemblies were inspected in accordance with the requirements of FAA AD 87-02-08 and Beechcraft SB 2182. Apparently none of the defects mentioned in SB 2182 were detected.

An inspection of the failed hinge attachment revealed there were no rivet heads missing. All the rivet heads were found in place. Further investigation revealed the shanks of the aluminium rivets had failed due to undetected corrosion in the rivet shanks. The corrosion was found in a narrow area between the steel plate of the stabiliser hinge block and the fuselage support structure which compromised the strength of the rivets.

Recommendation:

The CAA strongly recommends that operators and maintainers of affected aircraft accomplish the following additional requirements to Airworthiness Directive DCA/B23,24/17 (FAA AD 87-02-08 refers):

For further information refer to CASA AWB 27-017 issue 1, dated 5 September 2013 which can be obtained from the CASA web site at http://casa.gov.au/wcmswr/_assets/main/airworth/awb/27/017.pdf(external link)